International Ph: +61 286254531, +91 8147224208  

Surface Preparation - "Rubberising"

Some surfces may require additional protection or "rubberising". In this instance we reccomend Ultra-SuperSeal

Ute liners, trailers, caravans, farm implements, etc.

For optimal results in creating a "rubberising" surface in ute liners, trailers, caravans, farm implements, etc. state, please follow the instructions below for preparation and application. Links to the products utilised in this guide are listed below.

  1. Remove all fittings, roll bars etc.
  2. Wash down with general purpose cleaner or Ultra-Clean to remove all fat and oil deposits
  3. Rinse with clean water
  4. Roughen entire surface to be "rubberised" for better adhesion
  5. Remove all loose and flaking rust and paint. Do not use a rust remover
  6. Mask areas not to be "rubberised"
  1. Apply 1 coat Ultra-BondFirst or if rusted areas are present, substitute with Ultra-MetalPrimer
  2. Apply Ultra-SuperSeal by spray or brush
  3. Allow for 2 coats on sides and minimum of 3 coats on floor depending on the resistance required
  4. Apply a final coat of Ultra-Coat colour of choice over the Ultra-SuperSeal
  5. Remove masking tape immediately
  6. Allow to touch dry between coats
  7. "Rubberising" takes approximately 8 days to fully cure
Products that can be used